Roofing crew rolling out white TPO membrane across a flat commercial roofRoofer walking a flat commercial roof with a building owner during an inspection

Windsor Commercial Roofing Contractor

Curbs and Walkways Planned for Today's and Tomorrow's Equipment

As a Windsor commercial roofing contractor, we install roofs on warehouses and offices with the rooftop units, curbs, and future equipment planned in from the start.

Windsor Commercial Roofing Built Around Rooftop Equipment

Windsor commercial roofing jobs on warehouses and offices often carry more equipment every year, so the new roof should plan for what comes next.

Plain work truck staged beside a commercial building for a roofing job

We ask what is coming: a bigger unit, new exhaust fans, a solar array, or a tenant fit-out. Curbs and supports for those can go in during the reroof, flashed into the new membrane, instead of being cut in later by another trade.

Walkway pads then connect the hatch to every unit, so service visits stay off the field membrane.

  • Curbs sized for replacement units planned now
  • Supports for future solar or equipment flashed in
  • Walkway pads from the hatch to every unit

Commercial Roofing Problems Around Windsor Rooftop Equipment

Roofs with lots of equipment fail around the equipment first. These six are the usual suspects.

Curbs Cut in by Other Trades

Units added after the roof went on often sit on curbs flashed with caulk and tape instead of membrane.

Service Traffic Wear

Mechanics crossing the roof to units leave a worn path of scuffs and punctures without walkway pads.

Abandoned Curbs

Old curbs left after a unit is moved still pierce the deck, and their flashing ages with no one checking it.

Pipe and Conduit Supports

Gas lines and conduit resting on blocks cut into the membrane as they move with heat and cold.

Exhaust Fan Residue

Fans over break rooms and process areas leave residue that softens the sheet around their curbs.

Solar Racks on Old Roofs

Arrays set on a roof near the end of its life must come off again when that roof is replaced.

What Equipment-Ready Commercial Roofing Gives Windsor Buildings

Planning the equipment into the roof pays off in four ways.

Curbs Ready for the Next Unit

Curbs sized for the replacement unit mean a future swap needs no new hole in the membrane.

Marked Service Routes

Walkway pads guide mechanics along set paths, keeping boots and tools off the field.

Solar Supports Flashed In

Supports for a future array go in with the roof, so panels land on a new membrane rather than an old one.

Old Penetrations Closed

Abandoned curbs and pipes are removed and the deck patched, ending leaks from equipment no longer there.

Commercial Roofing Options for Windsor

Windsor roofs carrying equipment mostly take one of these systems.

Roofer heat-welding a TPO membrane seam with a hot-air welder

TPO Roofing

Equipment-heavy warehouse and office roofs get welded white membrane with preformed curb corners.

TPO Roofing details
Crew laying black EPDM rubber membrane on a flat commercial roof

EPDM Roofing

Simpler roofs with a few units take wide rubber sheets, with walkway pads to each unit.

EPDM Roofing details
Roofers working around rooftop units and exhaust stacks on a plant roof

Industrial Roofing

Buildings with process exhaust get a sheet rated for what the fans put on the roof.

Industrial Roofing details
Crew installing standing-seam metal panels on a commercial building

Commercial Metal Roofing

Sloped buildings and canopies get metal panels, with snow guards above rooftop equipment.

Commercial Metal Roofing details

New Unit Going on the Roof?

A new unit set on an old roof often means a new leak. Call before it is lifted and we will plan the curb and flashing.

How Commercial Roofing Work Runs in Windsor

Equipment steps and roof steps work together. Here is the order.

On The Roof
  1. On The Roof

    Step 1: Inspect Your Roof

    We list every unit, curb, fan, and pipe support, flag abandoned penetrations, and take core cuts across the field.

  2. On The Roof

    Step 3: Remove Old Curbs and Supports

    Abandoned curbs come out, the deck is patched, and new curbs and supports are set where equipment will sit.

  3. On The Roof

    Step 4: Install Membrane and Flash Equipment

    New insulation and membrane go down, every curb and support is flashed, and walkway pads connect the hatch to each unit.

Around The Building
  1. Around The Building

    Step 2: Plan With Your Mechanical Contractor

    Unit swaps, disconnects, and future equipment spots are set with your HVAC contractor and any solar installer.

  2. Around The Building

    Step 5: Hand Over a Roof Layout

    You get a simple roof plan showing units, curbs, walkways, and drains for future contractors to follow.

Commercial roofing nearby

Other Towns Near Windsor

Own buildings beyond Windsor? The towns below are in our area too; anywhere else, call us or send us a message.

8.4 mi
Miles from Hartford

Glastonbury

Metal roofs on farm buildings and shops.

3.8 mi
Miles from Hartford

East Hartford

Warehouse and retail membranes sized building by building.

6.2 mi
Miles from Hartford

Bloomfield

Campus roofs planned as one budget.

3.8 mi
Miles from Hartford

West Hartford

Storefront roofs worked around tenant hours.

4.4 mi
Miles from Hartford

Wethersfield

Roof repair records weighed before any replacement.

3.4 mi
Miles from Hartford

Blue Hills

School and church roofs timed around occupancy.

8.9 mi
Miles from Hartford

Avon

Drift loads checked at parapets and units.

10.6 mi
Miles from Hartford

Simsbury

Insulation upgrades cleared through the snow-load check.

7.3 mi
Miles from Hartford

South Windsor

Big roofs replaced section by section.

9.5 mi
Miles from Hartford

Weatogue

Core cuts decide recover or tear-off.

26.7 mi
Miles from Hartford

Windham

Roof material in one delivery, one crane day.

12.6 mi
Miles from Hartford

Bolton

Garage stacks and vents flashed tight.

29.0 mi
Miles from Hartford

Salem

Edge metal and coping checked after storms.

19.0 mi
Miles from Hartford

Barkhamsted

Cold-weather roof systems now, adhesives in spring.

Windsor Roofing Questions

Questions from Windsor owners with busy rooftops.

Crew tearing an old flat roof down to the deck before a replacement

Question about your own roof?

Call Us
Can you set curbs for equipment we have not bought yet?

Yes, if you know the size and location. A curb or support set and flashed during the reroof saves cutting into the new membrane later.

What adds to Windsor commercial roofing cost on an equipment-heavy roof?

Every curb, support, and pipe to flash adds labor, along with removing abandoned penetrations and laying walkway pads. Roofs with many units cost more per square foot than open ones.

Should solar go on before or after a new roof?

After. Panels set on an old roof must come off when that roof is replaced, so a new roof with flashed supports comes first.

Does commercial roofing for Windsor businesses include working with our HVAC company?

It does. We schedule disconnects, lifts, and unit swaps with your mechanical contractor so curbs and flashing are done once.

What should a Windsor commercial roofing near me search look for?

A contractor who lists your rooftop equipment, plans curbs for what is coming, and adds walkway pads. That is how we approach every equipment-heavy roof in town.

Do walkway pads really help?

Yes. Most punctures on busy roofs sit along the paths mechanics walk. Pads give them a marked route and take the wear off the membrane.

What happens to abandoned curbs and pipes?

They come out during the reroof. The opening is decked over and insulated, so the new membrane runs across it and the old leak point disappears with the equipment.

Do rooftop units need to come off for a reroof?

Not always. Many units can be lifted on their curbs just long enough to flash underneath, while others need a crane and a disconnect. We work that out with your mechanical contractor during planning, unit by unit.

Hire a Windsor Commercial Roofing Contractor

Send a list of what sits on the roof and what is coming. We will plan the curbs and walkways and price the new roof.

Call (475) 303-5902